DOOR SASH FILM INSTALLATION
id091600445600
1. Remove any grease or dirt from the affixing surface of the door.
2. Cut away the unused portion along the dotted lines.
3. Peel off the tape backing and attach the door sash film onto the door as shown in the figure.
-
Standard clearance
-
a: 4.0 mm {0.16 in}
b: 3.0—5.0 mm {0.12—0.19 in}
c: 3.0 mm {0.12 in} or more
4. Peel off the transparent protective film on the door sash film.
5. Install the following parts:
- (1) Rear door garnish (See REAR DOOR GARNISH REMOVAL/INSTALLATION.)
- (2) Rear beltline molding (See REAR BELTLINE MOLDING REMOVAL/INSTALLATION.)
- (3) Front beltline molding (See FRONT BELTLINE MOLDING REMOVAL/INSTALLATION.)
- (4) Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION.)
- (5) Sail inner garnish (See SAIL INNER GARNISH REMOVAL/INSTALLATION.)
- (6) Power outer mirror (See POWER OUTER MIRROR REMOVAL/INSTALLATION.)
- (7) Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION.)
- (8) Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION.)
