SIDE STEP MOLDING INSTALLATION


id091600717700

Note
•  Double-sided adhesive tape has already been adhered to a new side step molding for installation.
•  When a side step molding is to be reused, perform the following procedure:
1.  Remove any grease or dirt from the affixing surface of the side step molding.
2.  Affix double-sided adhesive tape to the position shown in the figure.
am2zzw00001907

1.  Install new clips A, B, C to the side step molding.

am2zzw00001908

2.  Peel the tape backing of double-sided adhesive tape to the position shown in the figure.

am2zzw00001909

3.  Install the side step molding while pushing the clip A, B and C installation area shown in the figure.

am2zzw00001910

4.  Press the position shown in the figure.

am2zzw00001911

5.  Install the rivet.

am2zzw00001912