SIDE STEP MOLDING INSTALLATION [3HB]

id0916007177z3

Note

•  Double-sided adhesive tape has already been adhered to a new side step molding for installation.

•  When a side step molding is to be reused, perform the following procedure:

1.  Remove any grease or dirt from the affixing surface of the side step molding.

2.  Affix double-sided adhesive tape to the position shown in the figure.

am2zzw00003400

1.  Install new clips A, B, C to the side step molding.

am2zzw00003401

2.  Peel the tape backing of double-sided adhesive tape to the position shown in the figure.

am2zzw00003402

3.  Install the side step molding while pushing the clip A, B and C installation area shown in the figure.

am2zzw00003403

4.  Press the position shown in the figure.

am2zzw00003404

5.  Install the rivet.

am2zzw00003405