WINDSHIELD WIPER MOTOR INSPECTION

id091900475000

1. Disconnect windshield wiper motor connector.

2. After connecting the windshield wiper motor terminal D or E to the positive battery terminal, and terminal C to the negative battery terminal, verify that the windshield wipers operate as shown in the table.

adejjw00003085

• If not as indicated in the table, replace the windshield wiper motor.

Terminal applied to battery

Operation condition

Battery positive voltage

Battery negative voltage

C

D

HI

E

LO

Terminal applied to battery	Operation condition
C	D	HI
E	LO

3. Disconnect the positive battery from terminal E while the wipers are operating, then verify that the wipers do not stop at the auto-stop position.

4. Connect windshield wiper motor terminals E and A, and apply battery positive voltage to terminal B.

5. Verify that the windshield wipers operate at low speed again and they are at the auto-stop position.

• If there is any malfunction, replace the windshield wiper motor.