REAR WIPER MOTOR INSPECTION

id091900475600

1.  Disconnect the negative battery cable.

2.  Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION.)

3.  Remove the rear wiper motor connector.

4.  Apply battery positive voltage to rear wiper motor connector terminal C, and connect terminals B and D to the ground.

5.  Verify that the rear wiper motor operates smoothly.

adejjw00003442

6.  Disconnect the ground connecting rear wiper motor connector terminal D and the negative battery terminal while the rear wipers are operating, then verify that the rear wipers stop at the auto-stop position.

am2zzw00002258

•  If there is any malfunction, replace the rear wiper motor.