NO.27 HOLD INDICATOR LIGHT DOES NOT ILLUMINATE WHEN HOLD SWITCH IS TURNED TO ON [FN4A-EL]


27	HOLD indicator light does not illuminate when HOLD switch is turned to ON
DESCRIPTION	• HOLD indicator light in dashboard does not illuminate when HOLD switch is turned on and IG SW at ON.
POSSIBLE CAUSE	• HOLD switch, HOLD indicator light or related wiring harness malfunction.


STEP	INSPECTION		ACTION
1	• Are other indicator lights illuminated with ignition switch is at ON?	Yes	Inspect meter fuse.
1		No	Go to next step.
2	• Check the HOLD switch (See HOLD SWITCH INSPECTION [FN4A-EL].) • Is HOLD switch normal?	Yes	Go to next step.
2		No	Repair or replace any defective parts.
3	• Disconnect PCM. • Turn ignition switch on. • Is voltage between 3Q terminal at the PCM connector and body ground more than 10.5 V?	Yes	Replace PCM.
3		No	Reconnect PCM. Go to next step.
4	• Inspect instrument cluster operation. (See INSTRUMENT CLUSTER INSPECTION.) • Is any malfunction detected?	Yes	Repair or replace malfunctioning part according to inspection result.
4		No	Inspect following wiring harnesses • Between instrument cluster terminal 2W and PCM terminal 1S • Between instrument cluster terminal 2X and PCM terminal 1W
5	• Verify test results. - If normal, return to diagnostic index to service any additional symptoms. - If malfunction remains, inspect related Service Information and perform repair or diagnosis. • If vehicle repaired, troubleshooting completed. • If vehicle not repaired or additional diagnostic information not available, replace PCM.