NO.28 HOLD INDICATOR LIGHT ILLUMINATES WHEN HOLD SWITCH IS NOT TURNED TO ON [FN4A-EL]


id0503a1815500

28

HOLD indicator light illuminates when HOLD switch is not turned to ON

DESCRIPTION

• HOLD indicator light in dashboard illuminates even though HOLD switch is turned off and IG SW at ON.

POSSIBLE CAUSE

• HOLD switch or related wiring harness malfunction.

Diagnostic procedure

STEP

INSPECTION

ACTION

1
• Check the HOLD switch
• Is HOLD switch normal?
Yes
Go to next step.
No
Repair or replace any defective parts.
2
• Disconnect PCM.
• Turn ignition switch off.
• Is resistance between 3Q terminal at the PCM connector and body ground more than 10 kilohms?
Yes
Replace PCM.
No
Inspect following wiring harnesses
• Between instrument cluster terminal 2W and PCM terminal 1S
• Between instrument cluster terminal 2X and PCM terminal 1W
3
• Verify test results.
- If normal, return to diagnostic index to service any additional symptoms.
- If malfunction remains, inspect related Service Information and perform repair or diagnosis.
• If vehicle repaired, troubleshooting completed.
• If vehicle not repaired or additional diagnostic information not available, replace PCM.