|
STEP
|
INSPECTION
|
ACTION
|
|
1
|
IDLING TEST
• Start the engine and warm up.
• Wait 3 s after select D range and depress the brake pedal.
• Dose HOLD indicator light flashing and fixed to 4GR?
|
Yes
|
Go to Step 4.
|
|
No
|
Go to next step.
|
|
2
|
DRIVING TEST
• Start the engine and warm up.
• Drive the vehicle within 3 s after select D range.
• Release the accelerator pedal with the vehicle accelerated (vehicle speed is 10 km/h {6.2 mph} or more) and drive the vehicle for 3 s or more with the brake pedal slightly depressed (brake switch is ON).
• Dose HOLD indicator light flashing and fixed to 4GR?
|
Yes
|
Go to next step.
|
|
No
|
No concern is detected at this position.
Inspect the vehicle speed sensor or harness/connector intermittent.
• If malfunction is detected, repair or replace defected part, then go to Step 5.
• If malfunction is not detected, then go to Step 5.
|
|
3
|
INSPECT THE VEHICLE SPEED SENSOR
• Is the vehicle speed sensor normal?
|
Yes
|
Go to Step 5.
|
|
No
|
Replace the vehicle speed sensor, then go to Step 5.
|
|
4
|
INSPECT THE DTC
• Turn the ignition switch to LOCK position.
• Turn the ignition switch to ON position.
• DTC P0752, is present?
|
Yes
|
Go to applicable DTC inspection.
|
|
No
|
Replace the forward clutch, then go to next step.
|
|
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform "After Repair Procedure".
• Are any DTCs present?
|
Yes
|
Go to applicable DTC inspection.
|
|
No
|
Troubleshooting completed.
|