STEP
|
INSPECTION
|
ACTION
|
1
|
• Turn ignition switch to ON position.
• In automatic mode, push down power window main switch for driver-side front window. Window should go down within approx. 42 s from ignition switch OFF position.
• In manual mode (finger continuously depressing power window main switch), window should go down within approx. 42 s from ignition switch OFF position.
• Does driver-side front window go down?
|
Yes
|
Go to the next step.
|
No
|
Replace power window main switch, then go to the next step.
|
2
|
• Turn ignition switch to ON position.
• In automatic mode, pull up power window main switch for driver-side front window. Window cannot go up within approx. 4 s from ignition switch OFF position.
• Verify that driver-side front window does not operate.
• Does driver-side front window go up?
|
Yes
|
Replace power window main switch, then go to the next step.
|
No
|
Go to the next step.
|
3
|
• Turn ignition switch to ON position.
• Lower driver-side front window completely.
• Take a hammer and hold it against the inside of the top of the window frame so that the window will hit its handle when it is closing.
• Raise the window using manual mode.
• When the window hits the hammer handle, does it immediately reverse and go down to approx. 200 mm {7.87 in} from the completely raised position?
|
Yes
|
Go to the next step.
|
No
|
Replace power window main switch, then go to the next step.
|
4
|
• Open any door.
• Turn ignition switch to ON position.
• Push/pull power window main switch for driver-side front window within approx. 42 s from ignition switch OFF position.
• Verify that driver-side front window does not go up or down.
• Does driver-side front window go up or down?
|
Yes
|
• Inspect door switch and related warning harness.
• If above parts are okay, replace power window main switch, then go to the next step.
• If above parts are incorrect, repair or replace malfunction part (s), then go to the next step.
|
No
|
Go to the next step.
|
5
|
• Close all doors.
• Turn ignition switch to ON position.
• Push/pull power window main switch for driver-side front window after approx. 60 s from ignition switch OFF position.
• Verify that driver-side front window does not go up or down.
• Does driver-side front window go up or down?
|
Yes
|
Replace power window main switch, then go to two-step down function inspection.
|
No
|
• IG OFF timer function is normal.
• Go to two-step down function inspection.
|