NO. 3 DRIVER-SIDE FRONT WINDOW REVERSES EVEN THOUGH THE GLASS DOES NOT ENCOUNTER A FOREIGN OBJECT WHILE IT IS GOING UP IN AUTOMATIC MODE


id0903a0872000

3

Driver-side front window reverses even though the glass does not encounter a foreign object while it is going up in automatic mode.

POSSIBLE CAUSE

• Too much driver-side front window friction resistance: Steps 1-5
• Short to ground in position sensor 1 signal from wiring harness (between power window main switch and driver-side front power window motor), inner driver-side front power window motor, or inner power window main switch: Steps 6, 7

Note
• If any malfunctions are repaired in any steps, be sure to perform initial setting and inspect again.

Diagnostic procedure

STEP

INSPECTION

ACTION

1
INSPECT FOR FOREIGN OBJECT IN DRIVER-SIDE FRONT WINDOW
• Is there a foreign object in driver-side front window?
Yes
Remove the object.
No
Go to the next step.
2
INSPECT ACRYLIC VISOR BRACKET INSTALLATION
• Is acrylic visor bracket properly installed?
Yes
Go to the next step.
No
Reinstall acrylic visor bracket properly.
3
INSPECT TO SEE IF GLASS RUN CHANNEL INTERFERES WITH DRIVER-SIDE FRONT WINDOW
• Remove driver-side front door trim.
• Does glass run channel interfere with driver-side front window?
Yes
Repair or replace glass run channel, then go to Step 8.
No
Go to the next step.
4
INSPECT LUBRICANT ON DRIVER-SIDE CARRIER PLATE
• Is there lubricant on driver-side carrier plate?
Yes
Go to the next step.
No
Apply lubricant (mineral oil).
5
INSPECT INSTALLATION OF DRIVER-SIDE FRONT POWER WINDOW SYSTEM COMPONENTS
• Are the following parts properly installed?
- Driver-side front door glass
- Driver-side power window motor wire
- Driver-side power window motor
- Driver-side power window regulator frame
- Driver-side carrier plate
- Driver-side glass run channel
Yes
Go to the next step.
No
Reinstall part (s) properly, then go to Step 8.
6
VERIFY POSITION SENSOR 1 OUTPUT SIGNAL
• Turn ignition switch to ON position.
• Test voltage at driver-side front power window motor connector terminal H (position sensor 1 signal).
• Is voltage alternate between 0 V and approx. 12 V when driver-side front window is being gone up and down at manual mode?
Yes
Go to the next step.
No
Replace driver-side front power window motor, then go to Step 8.
7
VERIFY WHETHER MALFUNCTION IS IN WIRING HARNESS (BETWEEN POWER WINDOW MAIN SWITCH AND DRIVER-SIDE FRONT POWER WINDOW MOTOR) OR POWER WINDOW MAIN SWITCH
• Turn ignition switch to LOCK position.
• Disconnect power window main switch.
• Is there continuity between power window main switch connector terminal B (position sensor 1 signal) and ground?
Yes
Repair wiring harness between power window main switch and driver-side front power window motor, then go to the next step.
No
Replace power window main switch (short to ground in power window main switch), then go to the next step.
8
RECHECK MALFUNCTION SYMPTOM AFTER REPAIR
• Did malfunction disappear?
Yes
• Troubleshooting completed.
• Explain repairs to customer.
No
Recheck malfunction symptoms, then repeat from Step 1 if malfunction recurs.