ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION [MZR 1.3, MZR 1.5]

id0140e6803200

Note

•  The APP sensor cannot be removed as a single unit. When replacing the APP sensor, replace it together with the accelerator pedal as a single unit.

am2zzw00006072

1.  Connect the M-MDS to the DLC-2.

am2zzw00001289

2.  Turn the ignition switch to the ON position.

3.  Verify that the APP sensor output voltage (PID: APP1, APP2) increases according to the increase in the accelerator opening angle when the accelerator opening angle is gradually increased. (See ON-BOARD DIAGNOSTIC TEST [MZR 1.3, MZR 1.5].)

•  If verified, go to the next step.

•  If not as verified, replace the accelerator pedal. (See ACCELERATOR PEDAL REMOVAL/INSTALLATION [MZR 1.3, MZR 1.5].)

4.  Verify that the APP sensor output voltage (PID: APP1, APP2) is within the specification when the accelerator pedal is depressed and not depressed.(See ON-BOARD DIAGNOSTIC TEST [MZR 1.3, MZR 1.5].) (See PCM INSPECTION [MZR 1.3, MZR 1.5].)

•  If not as specified, replace the accelerator pedal. (See ACCELERATOR PEDAL REMOVAL/INSTALLATION [MZR 1.3, MZR 1.5].)