DTC C0010:01/C0011:01/C0014:01/C0015:01/C0018:01/C0019:01/C001C:01/C001D:01 [ABS]

id0402a7877200

DTC

C0010:01

C0011:01

C0014:01

C0015:01

C0018:01

C0019:01

C001C:01

C001D:01

LF inlet solenoid valve system

LF outlet solenoid valve system

RF inlet solenoid valve system

RF outlet solenoid valve system

LR inlet solenoid valve system

LR outlet solenoid valve system

RR inlet solenoid valve system

RR outlet solenoid valve system

DETECTION CONDITION

•  Malfunction detected in the ABS HU/CM solenoid valve or internal circuit by the ABS HU/CM on-board diagnostic function

POSSIBLE CAUSE

•  Open or short circuit in the ABS HU/CM internal solenoid valves

•  Solenoid valve malfunction

•  Poor connection at connectors (female terminal)

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY SOLENOID VALVE OPERATION • Turn the ignition switch to the LOCK position. • Connect the M-MDS to the DLC-2. • Turn the ignition switch to the ON position (engine off). • Access the active command mode for the solenoid valve using the M-MDS. (See ON-BOARD DIAGNOSIS [ABS].) • Does the solenoid valve operate?	Yes	Go to the next step.
1		No	Replace the ABS HU/CM, then go to the next step. (See ABS HU/CM REMOVAL/INSTALLATION [L.H.D.].) (See ABS HU/CM REMOVAL/INSTALLATION [R.H.D.].)
2	VERIFY DTC TROUBLESHOOTING COMPLETED • Clear the DTC from the memory. (See ON-BOARD DIAGNOSIS [ABS].) • Start the engine and drive the vehicle at 10 km/h {6.2 mph} or more. • Gradually slow down and stop vehicle. • Are the same DTCs present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the ABS HU/CM, then go to the next step. (See ABS HU/CM REMOVAL/INSTALLATION [L.H.D.].) (See ABS HU/CM REMOVAL/INSTALLATION [R.H.D.].)
2		No	Go to the next step.
3	VERIFY AFTER REPAIR PROCEDURE • Are any other DTCs present?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [ABS].)
3		No	DTC troubleshooting completed.

DTC	C0010:01 C0011:01 C0014:01 C0015:01 C0018:01 C0019:01 C001C:01 C001D:01		LF inlet solenoid valve system LF outlet solenoid valve system RF inlet solenoid valve system RF outlet solenoid valve system LR inlet solenoid valve system LR outlet solenoid valve system RR inlet solenoid valve system RR outlet solenoid valve system
DETECTION CONDITION		• Malfunction detected in the ABS HU/CM solenoid valve or internal circuit by the ABS HU/CM on-board diagnostic function
POSSIBLE CAUSE		• Open or short circuit in the ABS HU/CM internal solenoid valves • Solenoid valve malfunction • Poor connection at connectors (female terminal)