DSC SENSOR INITIALIZATION PROCEDURE

id041500870000

Warning

•  If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the combined sensor or DSC HU/CM, make sure to perform the initialization procedure to insure proper DSC operation.

1.  Inspect the wheel alignment and the inflation pressure.

•  If there is any malfunction, adjust the applicable part.

2.  Park the vehicle on level ground.

3.  Turn the ignition switch to the LOCK position.

4.  Connect the M-MDS (IDS) to DLC-2.

am2zzw00001261

5.  After the vehicle is identified, select the following items from the initial screen of the IDS.

1.  Select “Chassis”.

2.  Select “ABS/DSC”.

3.  Select “Sensor Initialization”.

6.  Then, select items from the screen menu in the following order.

•  Brake Fluid Pressure Sensor

•  Lateral Acceleration Sensor

7.  Perform the initialization procedure according to the directions on the screen.