CLUTCH RELEASE CYLINDER REMOVAL/INSTALLATION [F35M-R]

id051005801300

Caution

•  Fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. If it is spilled, wipe it off immediately.

1.  Remove in the order indicated in the table.

2.  Install in the reverse order of removal.

3.  Bleed the air from the system. (See CLUTCH FLUID AIR BLEEDING/REPLACEMENT [F35M-R].)

4.  After installation, inspect the clutch pedal. (See CLUTCH PEDAL INSPECTION [F35M-R].)

am2zzw00005915

1	Clutch pipe and clutch hose
2	Clutch pipe (See Clutch Pipe Removal Note.) (See Clutch Pipe Installation Note.)
3	Clutch release cylinder

Clutch Pipe Removal Note

Caution

•  When disconnecting the clutch pipe, the seal ring installed to the end of the clutch pipe connector may fall off or remain on the clutch release cylinder side. If the clutch pipe is assembled with the seal ring not installed, it may cause fluid leakage from the clutch pipe connector or the clutch may not operate normally. When disconnecting the clutch pipe, remove the seal ring and clutch pipe connector as a single unit.

1.  Pull the clip to the position shown in the figure and pull out the clutch pipe connector straight to detach it.

am2zzw00001491

2.  Verify that the seal ring is removed together with the clutch pipe connector.

am2zzw00003988

Clutch Pipe Installation Note

1.  Verify that the seal ring is assembled to the clutch pipe so that the ends of the seal ring and the clutch pipe overlap each other.

am2zzw00003961

Caution

•  Verify that there is no chipping or damage to the seal ring of the clutch pipe connector.

•  Replace the damaged seal ring with a new one.

2.  Return the clip to the position shown in the figure.

am2zzw00001492

3.  Insert the clutch pipe connector straight.

4.  Pull the clutch pipe to verify that it does not come off, and reinsert it completely.