(2) Disconnect the input/turbine speed sensor connector.
am2zzw00000984
(3) Remove the input/turbine speed sensor from transaxle case.
(4) Remove the O-ring from input/turbine speed sensor.
2. Install the input/turbine speed sensor.
(1) Apply ATF to a new O-ring and install it on the input/turbine speed sensor.
(2) Install the input/turbine speed sensor using a new bolt to transaxle case.
Caution
• Always use a new bolt. If the removed bolt is reused, it may cause oil leakage.
• A sealant coating is applied to the input/turbine speed sensor installation bolt to prevent oil leakage from the installation bolt hole which passes through the component.
Tightening torque
8—11 N·m {82—112 kgf·cm, 71—97 in·lbf}
(3) Connect the input/turbine speed sensor connector.
