PRIMARY PULLEY SPEED SENSOR REMOVAL/INSTALLATION [DJVA-EL]


id051901286700

1.  Remove the primary pulley speed sensor.

(1)  Disconnect the negative battery cable.
(2)  Disconnect the primary pulley speed sensor connector.
(3)  Remove the primary pulley speed sensor.
(4)  Remove the O-ring
adejjw00002817

2.  Install in the primary pulley speed sensor.

(1)  Coat a new O-ring with CVT fluid, and install it to the pulley speed sensor.
(2)  After verifying the sensor condition, install the primary pulley speed sensor.
am3zzw00008504
Tightening torque
3.9—6.9 N·m {40—70 kgf·cm, 35—61 in·lbf}

3.  Connect the primary pulley speed sensor connector.

4.  Connect the negative battery cable.