FILAMENT REPAIR


id091200417200

1.  Clean the filaments using isopropyl alcohol.

2.  Affix tape along both sides of the filament to be repaired.

am2zzw00005742

3.  Apply commercially available silver paint using a fine-tipped tool such as a small brush or a drawing pen.

4.  After 2—3 min, peel off the tape being careful not to damage the painted area.

Caution
•  Do not operate the rear window defroster until the repaired area is completely dried to prevent a malfunction.

5.  Completely dry the repaired area referring the followings:

•  If the room temperature is 25 °C {77 °F}, leave it for 24 h.
•  When using a hot air blower, dry for 30 min at 150 °C {302 °F}.