REAR BELTLINE MOLDING REMOVAL/INSTALLATION

id091600447900

1.  Fully open the rear door glass.

2.  Remove clip A using a fastener remover and pull up the rear beltline molding in the direction of the arrow (1) shown in the figure.

am2zzw00006258

3.  Remove clip C using a fastener remover and pull up the rear beltline molding in the direction of the arrow (2) shown in the figure.

4.  Rotate the rear beltline molding in the direction of the arrow (3) shown in the figure and remove it while detaching tabs B.

5.  Install in the reverse order of removal.