AUTO LIGHT ILLUMINATION LEVEL SETTING

id091800470600

1.  Connect the M-MDS to the DLC-2.

am2zzw00005889

2.  After the vehicle is identified, select the following items from the initial screen of the M-MDS.

(1)  “Module Programming”

(2)  “Programmable Parameters”

(3)  “BCM/GEM”

3.  Select an item name, and then select option.

M-MDS display	Function	Initial setting	Settings	Control module
Rain light sensor illuminance setting	Auto light sensitivity can be changed.	Standard (Except Japan)	Extra High (Except Japan)/High (Except Japan)/Standard (Except Japan)/Low (Except Japan)/Extra Low (Except Japan)	BCM

Note

•  Other than the above conditions, an “Japan Only” command is also displayed, however, do not select the command because it is for use other than in Japan.

•  If the mode is set to “Extra High (Except Japan)” and “High (Except Japan)”, the illumination level for illuminating the TNS and headlight increases. Therefore, the TNS and headlights illuminate when the ambient light is brighter than when the level is set to “Standard (Except Japan)”. In addition, if the mode is set to “Low (Except Japan)” and “Extra Low (Except Japan)”, the illumination level for illuminating the TNS and headlights decreases. Therefore, the TNS and headlights illuminate when the ambient light is lower than when the level is set to “Standard (Except Japan)”.