CYLINDER BLOCK INSPECTION

id011000507200

1. Measure the cylinder block for distortion in six directions as shown in the figure using a straight edge and feeler gauge.

• If it exceeds the maximum specification, replace the cylinder block.

bp31je00000144

Maximum distortion, head gasket side of the cylinder block

0.10 mm {0.0039 in}

2. Measure the cylinder bore diameter using the cylinder gauge. The measurement position is in the X and Y directions at a point 43.9 mm {1.73 in} below the top surface of the cylinder as shown in the figure.

• If it is not within the specification, replace the cylinder block.

btstze00000040

Standard cylinder bore diameter

89.000—89.030 mm {3.5040—3.5051 in}