FUEL TEMPERATURE SENSOR INSPECTION [SKYACTIV-D 1.8]
id0140s1806400
-
Note
-
• The fuel temperature sensor cannot be removed as a single unit. When replacing the fuel temperature sensor, replace it together with the fuel injector as a single unit.
PID/DATA Monitor Inspection
1. Connect the M-MDS to the DLC-2.
2. Start the engine.
3. Access the following PCM PIDs using the M-MDS. (See PID/DATA MONITOR INSPECTION.)(See PID/DATA MONITOR TABLE [PCM (SKYACTIV-D)].)
-
• IFT1 (fuel temperature sensor (built into fuel injector No.1))
• IFT2 (fuel temperature sensor (built into fuel injector No.2))
• IFT3 (fuel temperature sensor (built into fuel injector No.3))
• IFT4 (fuel temperature sensor (built into fuel injector No.4))
4. Verify that the PID [IFT1]/[IFT2]/[IFT3]/[IFT4] values are nearly the same.
-