HEADLIGHT LEVELING ACTUATOR OPERATION CHECK MODE [AUTO LEVELING CONTROL MODULE]

id090277131200

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off or on).

3.  Turn on the headlights.

4.  Perform the following procedure using the M-MDS.

(1)  Press [Start] for the vehicle identification.

(2)  Press the [Toolbox] tab.

(3)  Press the [WorK Support] icon.

(4)  Press [LIGHTING SYSTEMS].

(5)  Press [Run] for [Simulation Testing for Headlight Leveling Actuator].

5.  Verify that the headlight optical axis lowers from the current position and returns the original position after 2 s.

•  If the headlight leveling actuator does not operate normally, replace the front combination light. (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION.)