DTC C0061:96 [AUTO LEVELING CONTROL MODULE]

id090277131400

Outline

System malfunction location

Acceleration sensor malfunction

Detection condition

•  The auto leveling control module cannot receive the signal from the acceleration sensor.

Fail-safe

•  The headlight leveling actuator is stopped at the position when the malfunction is determined.

Possible cause

•  Auto leveling control module internal malfunction

System wiring diagram

Not applicable

Connector diagram

Not applicable

System malfunction location	Acceleration sensor malfunction
Detection condition	• The auto leveling control module cannot receive the signal from the acceleration sensor.
Fail-safe	• The headlight leveling actuator is stopped at the position when the malfunction is determined.
Possible cause	• Auto leveling control module internal malfunction
System wiring diagram	Not applicable
Connector diagram	Not applicable

Diagnostic Procedure

Step

Inspection

Results

Action

1

INSPECT AUTO LEVELING CONTROL MODULE FOR MALFUNCTION

•  Clear the DTC recorded in the memory.
(See CLEARING DTC.)

•  Perform the DTC inspection for the auto leveling control module.
(See DTC INSPECTION.)

•  Is the same Pending DTC present?

Yes

Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.

(See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [(E)].)

If the CAN communication is normal, replace the auto leveling control module and perform the repair completion verification.

(See AUTO LEVELING CONTROL MODULE REMOVAL/INSTALLATION [(E)].)

No

Go to the next step.

Repair completion verification

VERIFY IF OTHER DTC IS DISPLAYED

•  Perform the DTC inspection.
(See DTC INSPECTION.)

•  Are any other DTCs displayed?

Yes

Repair the malfunctioning location according to the applicable DTC troubleshooting.

No

DTC troubleshooting completed.

Step	Inspection	Results	Action
1	INSPECT AUTO LEVELING CONTROL MODULE FOR MALFUNCTION • Clear the DTC recorded in the memory. (See CLEARING DTC.) • Perform the DTC inspection for the auto leveling control module. (See DTC INSPECTION.) • Is the same Pending DTC present?	Yes	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [(E)].) If the CAN communication is normal, replace the auto leveling control module and perform the repair completion verification. (See AUTO LEVELING CONTROL MODULE REMOVAL/INSTALLATION [(E)].)
1		No	Go to the next step.
Repair completion verification	VERIFY IF OTHER DTC IS DISPLAYED • Perform the DTC inspection. (See DTC INSPECTION.) • Are any other DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting.
Repair completion verification		No	DTC troubleshooting completed.