CONNECTIVITY MASTER UNIT (CMU) INSPECTION

id092000041100

Note

•  The integrity of the connectivity master unit (CMU) cannot be determined from a single part. When inspecting the connectivity master unit (CMU), perform the following procedure.

1.  Connect the M-MDS to the DLC-2.

2.  Perform the DTC inspection for the connectivity master unit (CMU) and verify if any DTCs related to the connectivity master unit (CMU) is detected. (See DTC INSPECTION.)

•  If DTCs are detected, repair the malfunctioning location according to the applicable DTC troubleshooting.(Refer to the [DTC TABLE [CONNECTIVITY MASTER UNIT (CMU)]] in the workshop manual)