FORCED IGNITION ON

id092100802500

Note

•  In order to perform a forced ignition ON, the M-MDS is necessary. If the servicing is being done outside of an Authorized Mazda dealership, contact an Authorized Mazda dealership for instructions.

•  The forced ignition ON procedure forces a power supply to each part when no power is available even after the ignition switch has been operated. However, the engine cannot be started and the steering cannot be unlocked.

•  When performing a forced ignition ON procedure, remove all remote transmitters from the vehicle. If a remote transmitter is left in the vehicle, the forced ignition ON procedure cannot be done.

1.  Verify that there are no remote transmitters in the vehicle.

2.  Connect the M-MDS to the DLC-2.

3.  Activate the M-MDS and perform the following procedure.

(1)  Press [Start] to start the vehicle identification.

(2)  Press the [Toolbox] tab.

(3)  Press the [Work Support] icon.

(4)  Press the [POWER SYSTEMS].

(5)  Press [Run] for [Compulsory Ignition ON].

4.  Switch the ignition ON according to the directions on the M-MDS screen.