DTC P253F:00 [MZR-CD 2.2]
id0102f3154400
|
DTC P253F:00 |
Engine oil deteriorated |
|---|---|
|
DETECTION CONDITION
|
• The PCM calculates engine oil attenuation based on fuel injection amount during diesel particulate filter regeneration. If the calculated engine oil attenuation amount is more than 35 %, the PCM determines that the engine oil amount level is deteriorated.
Diagnostic support note
• FREEZE FRAME DATA (mode2) and snapshot data are not available.
• The DTC is stored in the PCM memory.
|
|
POSSIBLE CAUSE
|
• Engine oil attenuation by frequently diesel particulate filter regeneration
• Engine oil data reset procedure does not perform in each engine oil replacements
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA (MODE2) OR SNAPSHOT DATA HAVE BEEN RECORDED
• Have FREEZE FRAME DATA (mode2) or snapshot data been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA (mode2) and snapshot data on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to available Service Information.
• If vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
REPLACE ENGINE OIL
• Replace the specified engine oil.
|
—
|
Go to the next step.
|
|
4
|
VERIFY TROUBLESHOOTING OF DTC P253F:00 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Switch the ignition to ON (engine off).
• Clear the DTC from PCM memory using the M-MDS.
• Start the engine.
• Is the PENDING CODE for this DTC present?
|
Yes
|
Replace the PCM, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform “AFTER REPAIR PROCEDURE”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [MZR-CD 2.2])
|
|
No
|
Troubleshooting completed.
|
||