DTC P1675 [MZ-CD 1.6 (Y6) (EURO4 emission level)]

id0102g6838900

DTC P1675

Fuel injector data incompatible

DETECTION CONDITION

•  The PCM reads the fuel injector correction data from EEPROM when the PCM is activated. If the PCM detects any of the following in the correction data, the PCM determines that there is an error in the injector data.

―  Check sum error

―  Data with value not within specification

POSSIBLE CAUSE

•  Fuel injector calibration code program procedure is not performed properly

•  PCM malfunction

DTC P1675	Fuel injector data incompatible
DETECTION CONDITION	• The PCM reads the fuel injector correction data from EEPROM when the PCM is activated. If the PCM detects any of the following in the correction data, the PCM determines that there is an error in the injector data. ― Check sum error ― Data with value not within specification
POSSIBLE CAUSE	• Fuel injector calibration code program procedure is not performed properly • PCM malfunction

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED • Has the FREEZE FRAME DATA been recorded?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY • Verify related service repair information availability. • Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. • If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	PERFORM FUEL INJECTOR CALIBRATION CODE PROGRAM • Clear the DTC from the PCM memory using the M-MDS. • Perform the FUEL INJECTOR CALIBRATION CODE PROGRAM. (See FUEL INJECTOR CALIBRATION CODE PROGRAM [MZ-CD 1.6 (Y6) (EURO4 emission level)].) • Run the vehicle under the FREEZE FRAME DATA stored condition. • Is the same DTC present?	Yes	Go to the next step.
3		No	Go to Step 5. (FUEL INJECTOR CALIBRATION CODE PROGRAM procedure is not performed properly.)
4	VERIFY THAT DTC P1675 TROUBLESHOOTING IS COMPLETED • Make sure to reconnect all disconnected connectors. • Clear the DTC from the PCM memory using the M-MDS. • Run the vehicle under the FREEZE FRAME DATA stored condition. • Is the same DTC present?	Yes	Repeat the inspection from Step 1. • If the malfunction recurs, replace the PCM. (See PCM REMOVAL/INSTALLATION [MZ-CD 1.6 (Y6) (EURO4 emission level)].) Go to the next step.
4		No	Go to the next step.
5	VERIFY AFTER REPAIR PROCEDURE • Perform the after repair procedure. (See AFTER REPAIR PROCEDURE [MZ-CD 1.6 (Y6) (EURO4 emission level)].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [MZ-CD 1.6 (Y6) (EURO4 emission level)].)
5		No	DTC troubleshooting completed.