FUEL FILTER (HIGH-PRESSURE) REMOVAL/INSTALLATION [ZY, Z6]

id0114b0803000

Warning

•  Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, always complete the “Fuel Line Safety Procedure”, while referring to “BEFORE SERVICE PRECAUTION”.

•  Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, before performing the fuel pump unit removal/installation, always complete the “Fuel Leak Inspection After Fuel Pump Unit Installation”.

Caution

•  Disconnecting/connecting the quick release connector without cleaning it may cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is free of foreign material.

1.  Complete the “BEFORE SERVICE PRECAUTION”. (See BEFORE SERVICE PRECAUTION [ZY, Z6].)

2.  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [ZY, Z6].)

3.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [ZY, Z6].)

4.  Remove the under cover. (See REAR TRAILING LINK REMOVAL/INSTALLATION.)

5.  Remove in the order indicated in the table.

am3zzw00007769

1	Quick release connector (See QUICK RELEASE CONNECTOR REMOVAL/INSTALLATION [ZY, Z6].)
2	Fuel filter (high-pressure)

6.  Install in the reverse order of removal.