HIGH PRESSURE FUEL PUMP INSPECTION [L3 Turbo]

id0114b4801500

Note

•  The following vacuum values are indicated by relative pressure from the fuel pressure sensor.

1.   Verify that the fuel pressure sensor is normal. (See FUEL PRESSURE SENSOR INSPECTION [L3 Turbo].)

2.  Connect the M-MDS to the DLC-2.

am3uuw00005788

3.  Turn the ignition switch to the ON position (Engine off).

4.   Select the FUEL_PRES, and LOAD, RPM PIDs on the M-MDS.

Caution

•  If the engine is run at a high speed, it could be damaged. When racing the engine, do not race it up to 6,700 rpm or more.

5.  After the LOAD PID is 60% or more while the engine is raced with the accelerator pedal fully depressed, verify that the FUEL_PRES PID is approx. 11.5 Mpa.

―  If not as verified, replace the high pressure fuel pump. (See HIGH PRESSURE FUEL PUMP REMOVAL/INSTALLATION [L3 Turbo].)