POSITIVE CRANKCASE VENTILATION (PCV) VALVE REMOVAL/INSTALLATION [ZY, Z6]

id0116a0819800

1.  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [ZY, Z6].)

2.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [ZY, Z6])

3.  Perform the following procedure.

Except U.K. specs.

1.  Remove the fresh-air duct and the air cleaner as a single unit. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [ZY, Z6].)

U.K. specs.

1.  Set the air cleaner cover out of the way with the PCM connector still connected. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [ZY, Z6].)

2.  Remove the fresh-air duct and the air cleaner case as a single unit. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [ZY, Z6].)

4.  Remove the intake manifold and the fuel distributor component as a single unit. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [ZY, Z6].)

5.  Disconnect the PCV hose from the PCV valve.

6.  Remove the dipstick pipe. (See CYLINDER HEAD GASKET REPLACEMENT [ZY, Z6].)

7.  Remove the positive crankcase ventilation valve and the oil separator as a single unit.

8.  Install in the reverse order of removal.