BAROMETRIC PRESSURE (BARO) SENSOR INSPECTION [MZR 2.0 DISI i-stop]

id0140j1801100

1.  Connect the M-MDS to the DLC‐2.

am3uuw00002612

2.  Switch the ignition to ON.

3.  Verify that the voltage (M-MDS PID: BARO) within the specification. (See PCM INSPECTION [MZR 2.0 DISI i-stop])

Note

•  Because the PCM is integrated in the BARO sensor, replacing the BARO sensor includes replacement of the PCM.

•  If not as specified, replace the PCM. (See PCM REMOVAL/INSTALLATION [MZR 2.0 DISI i-stop].)