FUEL PRESSURE SENSOR INSPECTION [MZR 2.0 DISI i-stop]

id0140j1801300

1. Connect the M-MDS to the DLC-2.

am3uuw00002394

2. Switch the ignition to ON (Engine off).

3. Select the FUEL_PRES PID on the M-MDS.

4. After warming up the engine, verify that the FUEL_PRES PID is at the standard value under the following conditions.

― If not as verified, replace the fuel delivery pipe. (See FUEL INJECTOR REMOVAL/INSTALLATION [MZR 2.0 DISI i-stop].)

Step

Condition

FUEL_PRES PID

1

•  Idle

•  90 s after engine is started

Approx. 3 MPa

2

•  Idle

•  Spill valve solenoid valve connector is disconnected

Approx. 530 kPa

Step	Condition	FUEL_PRES PID
1	• Idle • 90 s after engine is started	Approx. 3 MPa
2	• Idle • Spill valve solenoid valve connector is disconnected	Approx. 530 kPa

5. After connecting the spill valve control solenoid valve connector, clear the DTC.