PCM CONFIGURATION [MZR 2.0 DISI i-stop]

id0140j1802600

Note

•  Use the IDS (laptop PC) because the PDS (Pocket PC) does not support the PCM CONFIGURATION.

•  When replacing the following component and the PCM simultaneously, perform the PCM configuration first. If the operation amount is accidentally reset first, perform the PCM configuration, and then reset the operation amount again.

―  Starter relay

―  Starter

―  Fuel pump relay

―  Fuel pump

―  Power relay

―  Power drive relay

―  Charge relay

1.  Connect the M-MDS to DLC-2.

am3uuw00002395

2.  After the vehicle is identified, select the following items from the initial screen of the M-MDS.

•  When using the IDS (laptop PC)

1.  Select the “Module Programming”.

3.  Then, select items from the screen menu in the following order.

1.  Select “Programmable Module Installation”.

2.  Select “PCM”.

4.  Perform the configuration according to the directions on the screen.

5.  Retrieve DTCs by the M-MDS, then verify that there is no DTC present.

•  If a DTC(s) is detected, perform the applicable DTC inspection. (See DTC TABLE [MZR 2.0 DISI i-stop].)