ON-BOARD DIAGNOSTIC SYSTEM SIMULATION INSPECTION [DJVA-EL]

id050212290400

1. Connect the M-MDS to the DLC-2.

am3zzn00002895

2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

• When using the IDS (laptop PC)

1. Select "DataLogger".

2. Select "Modules".

3. Select "TCM".

• When using the PDS (Pocket PC)

1. Select "Module Tests".

2. Select "TCM".

3. Select "DataLogger".

3. Select the simulation items from the PID table.

4. Perform the simulation function, inspect the operations for each parts.

• If the operation of output parts cannot be verified after the active command mode inspection is performed, this could indicate the possibility of an open or short circuit, sticking, or operation malfunction in the output parts.

Simulation table

Item	Related to	Unit/Condition	Test condition
Item	Related to	Unit/Condition	Switch the ignition to ON	Idling
DS1	Shift control solenoid No.1	%	X	—
DS2	Shift control solenoid No.1	%	X	—
DSU	TCC engage solenoid	%	X	—
SL	TCC solenoid	On/Off	X	—
SLT	Belt grip pressure linear solenoid	A	X	—
TEST_WSPD	ABS malfunction determination avoidance mode	On/Off	X	X

X:Available