DTC P0883:00 [FN4A-EL]

id050218820100

DTC P0883:00

Battery voltage high

DETECTION CONDITION

•  The PCM detects that battery voltage is more than 16.02 V for 5 s.

Diagnostic support note

•  The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.

•  The AT warning light illuminates if the PCM detects the above malfunction condition during the first drive cycle.

•  PENDING CODE is available.

•  FREEZE FRAME DATA is available.

•  The DTC is stored in the PCM memory.

POSSIBLE CAUSE

•  Generator malfunction

•  PCM malfunction

DTC P0883:00	Battery voltage high
DETECTION CONDITION	• The PCM detects that battery voltage is more than 16.02 V for 5 s. Diagnostic support note • The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle. • The AT warning light illuminates if the PCM detects the above malfunction condition during the first drive cycle. • PENDING CODE is available. • FREEZE FRAME DATA is available. • The DTC is stored in the PCM memory.
POSSIBLE CAUSE	• Generator malfunction • PCM malfunction

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED • Has the FREEZE FRAME DATA been recorded on the repair order?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY • Verify related Service Information availability. • Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. • If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	VERIFY DTC HAVE BEEN PRESENTED • Switch the ignition to ON (Engine off). • Read the DTC in the PCM. • Is the DTC P2504:00 output?	Yes	Perform the “DTC P2504:00 Troubleshooting”. (See DTC P2504:00 [ZY, Z6].)
3		No	Go to the next step.
4	VERIFY TROUBLESHOOTING OF DTC P0883:00 COMPLETED • Make sure to reconnect all the disconnected connectors. • Clear the DTC using the M-MDS. • Perform the following procedure to ensure that the DTC has been resolved: 1. Start the engine. 2. Idle the engine for 5 s or more. • Is the same DTC present?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [FN4A-EL].)
4		No	Go to the next step.
5	VERIFY NO DTC HAS BEEN PRESENTED • Perform the “Reading DTCs Procedure”. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FN4A-EL].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FN4A-EL].)
5		No	DTC troubleshooting completed.