DTC P06B8:00 [FS5A-EL]

id050221325000

Note

• This DTC is applied to the following vehicles (VIN):

Applied VIN (assumed) :

― JMZ BL12F70# 100001—131132

― JMZ BL14F70# 100001—131132

― JMZ BLA2F70# 100001—131132

― JMZ BLA4F70# 100001—131132

― JM0 BL10F100 100001—158446

― JM0 BL10L100 100001—158446

― JM6 BL10F1*0 100001—158446

― JM7 BL04F**# 100001—131132

― JM7 BL12F**# 100001—158446

― JM7 BL22F**# 100001—158446

DTC P06B8:00

NVRAM malfunction

DETECTION CONDITION

•  The TCM detects NVRAM error.

Diagnostic support note:

•  The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle.

•  The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.

•  PENDING CODE is available.

•  FREEZE FRAME DATA is available.

•  The DTC is stored in the TCM memory.

POSSIBLE CAUSE

•  NVRAM in TCM malfunction

DTC P06B8:00	NVRAM malfunction
DETECTION CONDITION	• The TCM detects NVRAM error. Diagnostic support note: • The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle. • The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle. • PENDING CODE is available. • FREEZE FRAME DATA is available. • The DTC is stored in the TCM memory.
POSSIBLE CAUSE	• NVRAM in TCM malfunction

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED • Has the FREEZE FRAME DATA been recorded on the repair order?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY • Verify related Service Information availability. • Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. • If the vehicle is not repaired, go to the next step.
2		No	Replace the TCM, then go to the next step. (See TCM REMOVAL/INSTALLATION [FS5A-EL].)
3	VERIFY DTC TROUBLESHOOTING COMPLETED • Make sure to reconnect all the disconnected connectors. • Clear the DTC using the M-MDS. • Perform the following procedure to ensure that the DTC has been resolved: 1. Start the engine. 2. Idle the engine. • Is the same DTC present?	Yes	Replace the TCM, then go to the next step. (See TCM REMOVAL/INSTALLATION [FS5A-EL].)
3		No	Go to the next step.
4	VERIFY NO DTCs ARE PRESENT • Perform the “Reading DTCs Procedure”. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FS5A-EL].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FS5A-EL].)
4		No	DTC troubleshooting completed.