PRIMARY PULLEY SPEED SENSOR REMOVAL/INSTALLATION [DJVA-EL]

id051901286700

1. Remove the primary pulley speed sensor.

(1) Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [ZY, Z6].)

(2) Disconnect the negative battery cable.

(3) Disconnect the primary pulley speed sensor connector.

(4) Remove the primary pulley speed sensor.

(5) Remove the O-ring

adejjw00002817

2. Install in the primary pulley speed sensor.

(1) Coat a new O-ring with CVT fluid, and install it to the pulley speed sensor.

(2) After verifying the sensor condition, install the primary pulley speed sensor using a new bolt.

am3zzw00008504

Tightening torque

3.9—6.9 N·m {40—70 kgf·cm, 35—61 in·lbf}

3. Connect the primary pulley speed sensor connector.

4. Connect the negative battery cable.