DTC INSPECTION [Bluetooth SYSTEM (HANDS-FREE TELEPHONE (HF/TEL) SYSTEM)]

id0902g8440500

Note

•  All DTCs displayed in the DTC inspection should be entered in the Audio Repair Order Form.

Using the M-MDS

1.  Connect the M-MDS to the DLC-2.

am3uuw00003108

2.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

•  When using the IDS (laptop PC)

1.  Select “Self Test”.

2.  Select “Modules”.

3.  Select “ACU”.

•  When using the PDS (Pocket PC)

1.  Select “Module Tests”.

2.  Select “ACU”.

3.  Select “Self Test”.

3.  Verify the DTC according to the directions on the screen.

•  If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

4.  After completion of repairs, clear all DTCs stored in the Bluetooth unit. (See CLEARING DTC [Bluetooth SYSTEM (HANDS-FREE TELEPHONE (HF/TEL) SYSTEM)].)

Without Using M-MDS (On-board Diagnostic Test Mode)

1.  Switch the ignition to ACC or ON.

2.  While pressing the POWER/VOLUME switch, simultaneously press the PRESET switch 1 and the PRESET switch 6 for 2 s or more.

With RDS (radio data system)

am3uuw00003109

Without RDS (radio data system)

am3zzw00007432

Note

•  If several DTCs are in the memory, they can be displayed using the SEEK/TRACK switch (up or down).

amxzzw00001109

3.  To stop the on-board diagnostic test mode, ignition is switched to off.