DTC U3000:54 [REAR VEHICLE MONITORING SYSTEM]

id0902z2569200

DESCRIPTION

Radar aiming is not performed or radar sensor axis is deviated (Rear vehicle monitoring control module (RH))
DETECTION CONDITION
•  Rear vehicle monitoring control module (RH) radar aiming is out of range for 1 s or more.
POSSIBLE CAUSE
•  Rear vehicle monitoring control module (RH) radar aiming is not performed
•  Rear vehicle monitoring control module (RH) radar sensor axis is deviated
•  Rear vehicle monitoring control module (RH) malfunction

Diagnostic Procedure

STEP

INSPECTION

ACTION
1
PERFORM REAR VEHICLE MONITORING CONTROL MODULE (RH) RADAR AIMING
•  Perform the rear vehicle monitoring radar aiming (RH) using the M-MDS.
•  Clear the DTC from the rear vehicle monitoring control module using the M-MDS.
•  Verify the rear vehicle monitoring system DTC using the M-MDS.
•  Is the same DTC present?
Yes
Perform the rear vehicle monitoring radar aiming (RH) again using the M-MDS, then go to the next step.
(See REAR VEHICLE MONITORING RADAR AIMING.)
No
Go to Step 3.
2
VERIFY TROUBLESHOOTING COMPLETED
•  Clear the DTC from the rear vehicle monitoring control module using the M-MDS.
•  Verify the rear vehicle monitoring system DTC using the M-MDS.
•  Is the same DTC present?
Yes
Replace the rear vehicle monitoring control module (RH), then go to the next step.
(See REAR VEHICLE MONITORING CONTROL MODULE REMOVAL/INSTALLATION.)
No
Go to the next step.
3
VERIFY THAT NO OTHER DTCs ARE PRESENT
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [REAR VEHICLE MONITORING SYSTEM].)
No
DTC troubleshooting completed.