NO. 2 ALL METERS AND GAUGES DO NOT OPERATE [INSTRUMENT CLUSTER]

id0903d5807500

2

All meters and gauges do not operate

POSSIBLE CAUSE

•  Instrument cluster malfunction

•  Connector or pin malfunction

•  Fuse malfunction

•  Open or short circuit in power supply (IG1) wiring harness

•  Open or short circuit in ground wiring harness

2	All meters and gauges do not operate
POSSIBLE CAUSE	• Instrument cluster malfunction • Connector or pin malfunction • Fuse malfunction • Open or short circuit in power supply (IG1) wiring harness • Open or short circuit in ground wiring harness

Diagnostic procedure

STEP	INSPECTION		ACTION
1	• Switch the ignition to ON. • Inspect the following: ― Does the odometer/tripmeter illuminate? ― Does the instrument cluster illumination illuminate? (With panel light control switch) ― Does the fuel gauge operate? ― Does the MIL turn ON?	Yes	Troubleshooting completed. (The system is normal.)
1		No	Go to the next step.
2	• Inspect the METER fuse. • Is the fuse normal?	Yes	Go to the next step.
2	• Inspect the METER fuse. • Is the fuse normal?	No	Replace the fuse. • If the fuse is melted, inspect the wiring harness for a short to ground. Repair or replace the wiring harness, then replace the fuse.
3	• Inspect the DTC for the instrument cluster ON-BOARD DIAGNOSTIC SYSTEM. • Have any DTC’s been recorded in memory?	Yes	Perform the recorded DTC’s troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER].)
3		No	Go to the next step.
4	• Switch the ignition to Off. • Remove the instrument cluster. • Disconnect the instrument cluster connector. • Inspect the voltage between instrument cluster wiring harness-side connector terminal 2S. • Switch the ignition to ON. • Is the voltage B+?	Yes	Go to the next step.
4		No	Repair or replace for open circuit instrument cluster power supply circuit.
5	• Instrument cluster connector disconnected. • Verify continuity between instrument cluster wiring harness-side connector terminal 2A and ground. • Is there continuity?	Yes	Go to the next step.
5		No	Repair or replace for following: • Open circuit in wiring harness between instrument cluster terminal 2A and ground. • Poor contact or loose installation at ground point
6	• Switch the ignition to Off. • Inspect the instrument cluster connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion). • Are the terminals normal?	Yes	Replace the instrument cluster.
6		No	Repair or replace the terminal.