POWER WINDOW SYSTEM INITIALIZATION PROCEDURE

id091200413800

With Auto-Open/Close Function for All Windows

Note

•  Initial setting must be performed for the switch of each seat.

•  If the following operations have been performed, initial setting is reset, and auto up/down operation are disabled. Therefore, performing initial setting is necessary.

―  Negative battery cable disconnected or power window system power supply fuse removed. (perform initial setting for each door glasses.)

―  Power window switch connector disconnected. (perform initial setting for the switch connected with the connector)

1.  Switch the ignition to ON.

2.  Press the power window switch and fully open the suspect door glass.

3.  Pull up the power window main switch/sub switch to the manual-up position to fully close the suspect door glass, and keep holding the switch up at the position for approx.2 s.

With Auto-Open/Close Function for Driver-Side

Note

•  If the following operations have been performed, initial setting is reset, and auto up/down operation are disabled. Therefore, performing initial setting is necessary.

―  Negative battery cable is disconnected.

―  Power window main switch connector is disconnected.

―  Power window system power supply fuse is removed.

1.  Switch the ignition to ON.

2.  Press the driver's seat switch to fully open the door glass.

3.  Pull up the driver's seat switch to the manual-up position to fully close the door glass and keep holding the switch up at the position for approx. 2 s.