STARTER REMOVAL/INSTALLATION [LF, L3]


id0119b2800200

Warning
•  When the battery cables are connected, touching the vehicle body with starter terminal B will generate sparks. This can cause personal injury, fire, and damage to the electrical components. Always disconnect the negative battery cable before performing the following operation.

1.  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L3].)

2.  Disconnect the negative battery cable.

3.  Remove the under cover.

4.  Set the clutch release cylinder out of the way (MTX). (See MANUAL TRANSAXLE REMOVAL/INSTALLATION [G66M-R].)

5.  Remove in the order indicated in the table.

6.  Install in the reverse order of removal.

am3zzw00001152

1
Terminal B cable
2
Terminal S connector
3
Wiring harness bracket
4
Starter


Starter Installation Note

Note
•  If there is peeling on or damage to the insulator, attach a new insulator using the following procedure:
acxaaw00000762

1.  Peel off the insulator from the starter completely using a scraper.

2.  Degrease the insulator attachment area.

acxaaw00000763

3.  Attach a new insulator to the starter.

acxaaw00000764