ACCELERATOR PEDAL POSITION (APP) SENSOR CONSTRUCTION/OPERATION[LF, L3]


id0140a9174800

•  The sensor is installed on the accelerator pedal and detects how much the accelerator pedal is depressed.
am3zzn00001358

1
APP sensor
2
Accelerator pedal

•  The electromagnetic induction type induction type has been adopted on the sensor.
•  A non contact type sensor has been adopted to improve durability.
•  The APP sensor is composed of the main sensor and sub sensor, and detects the accelerator opening angle with these two sensors (main and sub).
•  Even if a malfunction occurs in either one of the sensors, the detection is performed with a normal sensor drive-by-wire control is maintained.
•  If both the MAIN and SUB sensors for the APP sensor malfunction, signals necessary for the drive-by-wire control are not input to the PCM and the drive-by-wire control is disabled.
•  However, even though the drive-by-wire control is disabled, the throttle valve opening angle necessary for minimum driving is maintained mechanically.
am3zzn00001420

1
APP sensor
2
Rotor coil
3
Excitation coil
4
Receiving coil
5
Analog
6
Main sensor and sub sensor characteristic
7
Output
8
High
9
Low
10
Accelerator pedal depression amount
11
Small
12
Large