CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION[L3 Turbo]

id0140b6801600

Note
•  Before performing the following inspection, make sure to follow the troubleshooting flowchart. (See FOREWORD[L3 Turbo].)

Continuity Inspection

1.  Remove the CPP switch.

2.  Verify that the continuity between CPP switch terminals A and B is as indicated in the table.

am3uuw00000128

•  If there is no malfunction, perform the “Circuit Open/Short Inspection”.
•  If there is any malfunction, replace the CPP switch.

Measurement condition

Continuity
Push the rod.
No continuity
Except above
Continuity detected


Circuit Open/Short Inspection

e3u140zw6204
e3u140zw6991

1.  Disconnect the PCM connector.

2.  Disconnect the CPP switch connector.

3.  Inspect the following wiring harnesses for an open or short circuit. (Continuity inspection)


Open circuit

•  If there is no continuity in the following wiring harnesses, there is an open circuit. Repair or replace the wiring harness.
―  CPP switch terminal A and PCM terminal 1D
―  CPP switch terminal B and body ground


Short circuit

•  If there is continuity in the following wiring harnesses, there is a short circuit. Repair or replace the wiring harness.
―  CPP switch terminal A and body ground
―  CPP switch terminal A and power supply
―  CPP switch terminal B and power supply