REAR BRAKE (DISC) REMOVAL/INSTALLATION

id041100800500

Caution

•  If the brake hose is installed to the caliper on the vehicle, the tool cannot be installed correctly resulting in brake fluid leakage due to improper installation. Therefore, remove the caliper and brake hose as a single unit when removing the caliper or brake hose, and tighten the brake hose to the caliper to the specified torque, then install the caliper and brake hose as a single unit when installing to the vehicle.

1.  Remove in the order indicated in the table.

2.  Install in the reverse order of removal.

3.  After installation, pump the brake pedal a few times and inspect the following:

―  Parking brake lever stroke

―  Brake drag

am3zzw00004255

1	Parking brake cable
2	Brake pipe (See Clip and Brake Pipe Installation Note.)
3	Clip (See Clip and Brake Pipe Installation Note.)
4	Retaining clip (See FRONT BRAKE (DISC) REMOVAL/INSTALLATION [L3 Turbo].)
5	Cap
6	Bolt
7	Caliper, brake hose (See Caliper and Brake Hose Removal Note.) (See Caliper and Brake Hose Installation Note.)
8	Boot
9	Brake hose (See Brake Hose Installation Note.)
10	Caliper
11	Disc pad
12	Bolt
13	Mounting support
14	Disc plate

Caliper and Brake Hose Removal Note

1.  Remove the caliper and brake hose from the vehicle as a single unit.

Brake Hose Installation Note

1.  Secure the caliper to the vise and install the brake hose to it.

am3zzw00004285

Caution

•  Insert a protective plate into the vise opening so as not to damage the caliper.

2.  Tighten the brake hose to the specified torque.

am3zzw00004286

Caliper and Brake Hose Installation Note

1.  Clean the exposed area of the piston.

2.  Install the SST (49 F043 002) to the SST (49 B043 005).

aaxjjw00003396

3.  Align the SST projection to the piston groove.

4.  Rotate part A on the SST in the direction of the arrow and secure the SST to the caliper.

aaxjjw00003397

5.  Rotate the SST in the direction of the arrow and push the piston completely into the caliper.

aaxjjw00003398

Note

•  Even with the piston completely pushed in, the top the piston projects from the dust seal by approximately 2 mm {0.09 in}.

6.  Rotate part A on the SST in the direction of the arrow using the tool and remove the SST from the caliper.

aaxjjw00003399

7.  Install the caliper and brake hose to the vehicle as a single unit.

Clip and Brake Pipe Installation Note

1.  Install the brake hose to the vehicle-side bracket and secure it using a clip.

2.  Verify that the brake hose is not twisted.

3.  Tighten the brake pipe to the specified torque using the SST (49 0259 770B).