INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [FS5A-EL]

id051721801300

1.  Remove the battery duct and battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L3].)

2.  Disconnect the negative battery cable.

3.  Remove the battery, battery box and battery tray. (See BATTERY REMOVAL/INSTALLATION [LF, L3].)

4.  Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF, L3].)

5.  Disconnect the input/turbine speed sensor connector.

am3zzw00003425

6.  Remove the input/turbine speed sensor.

7.  Apply ATF to a new O‐ring and install it on a new input/turbine speed sensor.

8.  Install the input/turbine speed sensor using a new bolt.

Caution

•  Always use a new bolt. If the removed bolt is reused, it may cause oil leakage.

•  A sealant coating is applied to the input/turbine speed sensor installation bolt to prevent oil leakage from the installation bolt hole which passes through the component.

9.  Connect the input/turbine speed sensor connector.

10.  Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF, L3].)

11.  Install the battery, battery box and battery tray. (See BATTERY REMOVAL/INSTALLATION [LF, L3].)

12.  Connect the negative battery cable.

13.  Install the battery duct and battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L3].)