DTC B1318
Input voltage low
DETECTION CONDITION
• Voltage detected at water heater unit terminals E is less than 9 V.
POSSIBLE CAUSE
• Generator malfunction
• Battery malfunction
DTC B1318 [WATER HEATER SYSTEM]
id070228815500
|
DTC B1318 |
Input voltage low |
|---|---|
|
DETECTION CONDITION
|
• Voltage detected at water heater unit terminals E is less than 9 V.
|
|
POSSIBLE CAUSE
|
• Generator malfunction
• Battery malfunction
|
|
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
INSPECT BATTERY VOLTAGE
• Measure battery voltage.
• Is voltage more than 9 V?
|
Yes
|
Go to the next step.
|
|
No
|
Battery is weak.
• Inspect charging system.
|
||
|
2
|
INSPECT WIRING HARNESS BETWEEN W.HEAT 40 A FUSE AND WATER HEATER UNIT
• Turn ignition switch to ON position.
• Measure voltage at water heater unit connector terminal E.
• Is voltage more than 9 V?
|
Yes
|
Go to the next step.
|
|
No
|
Repair wiring harness.
|
||
|
3
|
INSPECT WATER HEATER UNIT
• Clear the DTC. (See CLEARING DTC [WATER HEATER SYSTEM].)
• Perform the KOEO Self Test. (See DTC DISPLAY [WATER HEATER SYSTEM].)
• Is the same DTC present?
|
Yes
|
Replace the water heater unit.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the after repair procedure. (See CLEARING DTC [WATER HEATER SYSTEM].)
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC troubleshooting.
|
|
No
|
Troubleshooting completed.
|
||