MAGNETIC CLUTCH DISASSEMBLY/ASSEMBLY[MZ-CD 1.6 (Y6)]

id0740b3800400

1.  Disassemble in the order indicated in the table.

am3zzw00000858

1	Nut (See Nut Removal/Installation Note.)
2	Pressure plate
3	Shim
4	Snap ring
5	A/C compressor pulley (See A/C Compressor Pulley Removal Note.) (See A/C Compressor Pulley Installation Note.)
6	Snap ring
7	Screw (See Screw Installation Note.)
8	Oil plug
9	O-ring (See O-ring Installation Note.)
10	Stator
11	A/C compressor body

2.  Assemble in the reverse order of disassembly.

3.  Adjust the magnetic clutch clearance. (See MAGNETIC CLUTCH ADJUSTMENT[MZ-CD 1.6 (Y6)].)

Nut Removal/Installation Note

1.  When removing or installing the nut, hold the pressure plate in place as shown in the figure.

am3zzw00000859

2.  When installing a new A/C compressor body, replace the recommended nut.

A/C Compressor Pulley Removal Note

1.  Remove the A/C compressor pulley using any commercially available puller and appropriate round rod.

am3zzw00000860

Screw Installation Note

1.  When installing a new stator, replace the screw.

O-ring Installation Note

1.  When installing a new oil plug, replace the O-ring.

A/C Compressor Pulley Installation Note

1.  Install the A/C compressor pulley using any commercially available pulley, and the SST (49 T028 301).

am3zzw00000861

Caution

•  If the SST (49 T028 301) installation position is misaligned while press fitting the A/C compressor pulley, it could cause interference with the A/C compressor shaft resulting in damage. Press fit the A/C compressor pulley carefully while verifying the position of the SST (49 T028 301) and shaft.