DTC INSPECTION[IMMOBILIZER SYSTEM (ADVANCED KEYLESS SYSTEM)]

id0902e3800200

Security Light

1.  Turn the ignition switch to the ON position.

2.  Verify the security light state.

•  If there is any malfunction:

―  After any malfunction is detected, the security light will function as follows for approx. 1 min.

•  DTC 16 and lower: Flashes

•  DTC 21 and higher: Illuminated

•  If there is no malfunction:

―  The security light illuminates for approx. 3 s and goes out.

3.  When any malfunction has been detected, read DTCs via flashing patterns displayed after the security light flashes or is illuminated for approx. 1 min.

•  Perform troubleshooting according to the corresponding DTC inspection.

Note

•  A verified DTC is flashed 10 times repeatedly by the security light.

•  If multiple DTCs are verified, the security light displays only the smallest DTC.

M-MDS

1.  Connect the M-MDS to the DLC-2.

am3zzw00001859

2.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

•  When using the IDS (laptop PC)

―  Select the “Toolbox” tab.

―  Select “Self Test”.

―  Select “Modules”.

―  Select “RKE”.

•  When using the PDS (Pocket PC)

―  Select “Module Tests”.

―  Select “RKE”.

―  Select “Self Test”.

3.  Verify the DTC according to the directions on the screen.

•  If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

4.  Disconnect the M-MDS.