SUNROOF UNIT DISASSEMBLY/ASSEMBLY

id091500800800

1.  Disassemble in the order indicated in the table.

2.  Assemble in the reverse order of disassembly.

am3zzw00002253

1	Screw A
2	Drip rail
3	Sunshade stopper
4	Screw B
5	Sunshade
6	Deflector
7	Screw C
8	Sunroof motor (See Sunroof Motor Assembly Note.)
9	Rear drip (See Rear Drip Assembly Note.)
10	Guide
11	Decoration link
12	Guide stopper
13	Tape protector
14	Short cord
15	Frame

Rear Drip Assembly Note

Note

•  If the rear drip is removed, butyl seal must be applied when re-installing.

1.  Apply a 6.0—8.0 mm {0.24—0.31 in} wide line of butyl seal to the area shown in the figure.

am3zzw00002254

Sunroof Motor Assembly Note

Note

•  If the guide is removed, initial position setting of the sunroof motor will be required. After installing the sunroof unit, perform initial position setting using the following procedure.

1.  Press the TILT UP switch to fully tilt up the glass panel.

2.  When the glass panel reaches the fully tilt up position, temporarily release the TILT UP switch and press it again for approx. 13 s continuously. Continue pressing the switch until the glass panel automatically stops at the fully tilt up position after reaching the mechanical lock position.

3.  When the glass panel stops at the fully tilt up position, temporarily release the TILT UP switch, then press it again within 5 s and hold.

Note

•  Press the TILT UP switch continuously until the glass panel opens to the fully open position, returns to the fully closed position and then stops.

4.  Release the TILT UP switch when the glass panel stops at the fully closed position.